Free bill analysis - bring a power bill, get the production math for your actual roof, panel brands like Qcells and REC compared side by side
If the pitch starts at your door and ends with "sign tonight for the special," sleep on it. The sun will still be there tomorrow; so will we.
Before
After
Before
After
Before
AfterFast, Reliable Solar Panel Cleaning Across Bloomington
Solar panel cleaning in Bloomington typically runs $150-$350 for a standard residential array, and most jobs are finished in under two hours. If your panels sit under the I-10 truck corridor or near the BNSF rail lines, you’ll likely need cleaning every 60-90 days instead of the twice-a-year schedule that works for coastal cities. Gus Petrakis and his crew answer the phone live at (877) 550-6892, and we’re usually on a Bloomington roof within 48 hours of your call.
We know Bloomington’s dust. It’s not the same dust you get in Fontana or Rialto. It’s diesel soot from 25,000 trucks a day on I-10, fine particulate from the rail yards, and alkaline desert grit that bakes onto glass in the San Bernardino Valley heat. That combination cuts panel output faster here than almost anywhere else in the Inland Empire, and it’s why we built our cleaning schedules around Bloomington’s actual soiling rate, not a generic calendar.
Gus has been doing this since 2011, and his name is on the truck. No subs, no call center, no pressure. Just a straight answer and a clean array.
Why Gus’s Solar Is Bloomington’s Preferred Solar Panel Cleaning Company
We’re the Solar Panel Cleaning team Bloomington homeowners call when the array stops producing and nobody can explain why. Usually the reason is simple: a film of diesel soot and basin dust thick enough to block 12-18% of the sunlight. We’ve cleaned panels on Alder Avenue, along Jurupa, and across the 92316 zip code, and the pattern is consistent. Bloomington panels get dirty faster than panels ten miles west, and the difference shows up in the true-up bill.
Part of what makes us different is that we pre-check the jurisdiction on every job. Bloomington is unincorporated San Bernardino County, which means any electrical or structural work tied to panel servicing runs through the County’s Land Use Services and Building & Safety divisions, not a city hall. Out-of-area crews who pull a Fontana or Rialto permit packet by mistake lose weeks to rejection letters. We don’t make that mistake, because we’ve been working inside the county system for over a decade.
We also don’t hand the work to a sub. The background-checked, uniformed crew that shows up is Gus’s own. You know who’s on your roof before the ladder comes off the truck. And if anything isn’t right, the 90-Day Done Right Promise means one call brings Gus back.
Our Solar Panel Cleaning Services in Bloomington
Residential Panel Cleaning
Most Bloomington homes have 12 to 28 panels on a single-story ranch roof, and the work is straightforward: deionized water, soft brushes, and a rinse that leaves no mineral spotting. We clean the glass, check the frame seals, and flag anything that looks like heat damage or arc faulting while we’re up there. A typical 20-panel system in Bloomington takes about 90 minutes and runs $180-$300.
Commercial Array Cleaning
Bloomington’s warehouse and industrial rooftops collect soot at a rate that surprises anyone who hasn’t worked in this corridor before. We clean commercial arrays after hours or on weekends so your operation doesn’t pause, and we schedule recurring service based on the array’s actual soiling pattern, not a default quarterly plan. Commercial pricing starts around $250 for small rooftop arrays and scales with panel count and roof access.
Bird & Critter Guard Installation
Pigeons and ground squirrels are a real problem on Bloomington’s large, unpaved lots. Birds nest under panels and leave droppings that etch glass over time; squirrels chew through wiring and leave debris piles that block airflow. We install galvanized mesh guard around the array perimeter, and for ground mounts on manufactured-home lots, we add skirting that keeps burrowing animals out of the racking footprint. Guard installation runs $200-$450 depending on array size and access.
Debris & Soiling Removal
This is the service Bloomington needs most. Between I-10 truck exhaust, BNSF/UP rail dust, and the basin’s PM2.5 load, panels here accumulate a film that cuts output 12-18% within 60-90 days. Even a light Santa Ana wind deposits a layer of grit that hardens in the heat. We remove it with a two-step process: a deionized water rinse to float the particulate, then a soft-brush pass that pulls the soot film off the glass without scratching it. Debris-only cleaning runs $150-$250 for most residential arrays.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Bloomington
We clean and maintain arrays built with Panasonic, Canadian Solar, JinkoSolar, and FranklinWH equipment, among others. The brand matters less than the soiling, but it helps to know your system’s inverter behavior, because on a 105°F Bloomington afternoon a SolarEdge or Enphase inverter under heavy soiling clips production harder than the panel spec sheet suggests. We carry the cleaning supplies and diagnostic tools to handle all of these systems, and we don’t need to order anything special to service a Bloomington job. If we say we’ll be there Thursday, we’re there Thursday.
Common Solar Panel Cleaning Problems We See in Bloomington Homes
- Diesel soot that bakes on after 60-90 days. If you live within a mile of I-10 or the rail corridor, your panels are pulling exhaust particulate out of the air constantly. The film starts as a film, then hardens in the summer heat until it takes more than a garden-hose rinse to remove.
- Older 100-amp service panels faulting under load. Many 1950s-1980s Bloomington ranches still carry the original electrical panel. When we find arc faults or hot spots during a cleaning visit, we can’t just reset the breaker, because any electrical work on an unincorporated county property needs a county permit. We coordinate that paperwork so your array isn’t down longer than it has to be.
- Sinking ground-mounted arrays on large lots. Manufactured-home parcels in Bloomington often use ground mounts, and the local soil compacts unevenly over time. A rack that has drifted 5 degrees off azimuth loses production silently. Cleaning is when we catch it.
- Santa Ana grit that scratches glass. A windy week in the fall kicks up gravel dust that settles on panels and turns the glass into 80-grit sandpaper if you wipe it dry. We never dry-wipe. Deionized water first, always.
Pricing for Solar Panel Cleaning in Bloomington, CA
A standard residential cleaning in Bloomington runs $150-$350 depending on array size, roof pitch, and how long it’s been since the last wash. Commercial arrays start around $250. Bird guard installation adds $200-$450. If you’re on a recurring schedule, our per-visit rate drops, and we’ll set the frequency based on your array’s actual soiling pattern, not a default quarterly plan. No trip charge inside our own county, and a Senior or Veteran discount of 10% never expires. Call (877) 550-6892 for an exact quote. Estimates are free, and nobody will ask you to sign anything tonight.
We Also Serve Cities Near Bloomington
Our crews run cleaning routes through Bloomington and the surrounding communities every week, so we’re usually on your roof within 48 hours. If you’re in Fontana, Rialto, Glen Avon, or Pedley, you’re inside our normal service area. Same crew, same county permitting knowledge, same 90-Day Done Right Promise on every job.
Serving Bloomington, CA - Our Local Coverage Area
We’re based in the Bloomington area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Solar Panel Cleaning in Bloomington
Bloomington sits directly under the Inland Empire’s heaviest goods-movement corridor, so diesel soot from I-10 truck traffic and the BNSF/UP rail lines deposits on panels at a rate that doesn’t apply in Fontana or Riverside. The San Bernardino Valley basin also traps PM2.5 and PM10 particulate against the foothills, and summer heat bakes that film onto the glass. Plan on cleaning every 60-90 days here, not the twice-yearly schedule that works in cleaner air basins. Call (877) 550-6892 and we’ll set a frequency that matches your actual soiling, not a generic calendar.
Cleaning itself doesn’t require a county permit, and routine washing won’t void your panel or inverter warranty as long as it’s done with deionized water and soft brushes, which is our standard. But if the cleaning uncovers an electrical issue that needs repair, any electrical work on Bloomington property must go through San Bernardino County’s Land Use Services and Building & Safety divisions, not a city hall. We handle that paperwork in-house. An out-of-area crew that pulls the wrong jurisdiction by mistake can leave you waiting weeks. We don’t have that problem.
If your Bloomington ranch still has the original 100-amp service, turn off the main breaker and look for any charring, melted insulation, or a burning smell near the panel. If you see any of that, call (877) 550-6892 before we arrive, and we’ll coordinate the county electrical permit as part of the service call. Do not open the panel cover yourself. Arc faults and hot spots are serious fire risks, and a trained electrician should inspect any panel that shows signs of stress.
Compare your current true-up period’s total production against the same period from the year before, then check your inverter’s online monitoring for per-panel output. A 12-18% production drop that recovers after cleaning is textbook soiling loss, and it translates directly into dollars on your true-up bill. If your SolarEdge or Enphase monitoring shows clipping on hot afternoons that disappears after a wash, the cleaning is paying for itself. Bring us a bill, and Gus will walk you through the math.
No permit is required for cleaning or debris removal on an existing installation. You only need a county permit if the cleaning uncovers structural or electrical damage that has to be repaired, like loose racking, damaged wiring, or a shifted ground mount. We assess that on site and tell you straight whether a permit is involved before any work starts. Call (877) 550-6892 for a free post-storm inspection. We’ll be out within 48 hours.
Written by Gus Petrakis, Owner at Gus’s Solar, serving Bloomington since 2011.