Free bill analysis - bring a power bill, get the production math for your actual roof, panel brands like Qcells and REC compared side by side
If the pitch starts at your door and ends with "sign tonight for the special," sleep on it. The sun will still be there tomorrow; so will we.
Fast, Reliable EV Charger Installation Across Encino
A Level 2 EV charger installation in Encino typically runs $1,100 to $3,200, including the charger, wiring, breaker, and labor. Panel upgrades, when needed, add $2,000 to $4,500. We get to Encino fast, usually within one business day, and we do the job in one trip.
If you live in Encino, you know the morning commute down Ventura Boulevard or the 101 doesn’t wait for a slow charger. A Level 2 charger adds 25 to 30 miles of range per hour, so you wake up with a full battery instead of a trickle. Call us at (877) 550-6892 and we’ll give you a straight quote, no pressure, no same-day signature demands.
Why Gus’s Solar Is Encino’s Preferred EV Charger Installation Company
We’re not a pop-up crew. Gus Petrakis founded this company in 2011, and his name is on the truck, the estimate, and the warranty. When you call, a live person answers. Not a voicemail, not a call center three states away. That matters when you’re trying to get a charger installed before your new EV shows up and you have questions about your panel, your garage, or your driveway layout.
Encino customers call us because we know this area. We know the 1950s ranch homes north of Ventura with their specific panel configurations. We know the hillside estates south of Ventura where long runs from panel to charger are the norm. Our EV Charger Installation team has been in and out of driveways across 91316, 91426, and 91436 for years. We show up when we say we will, and we leave the job site clean.
Our 90-Day Done Right Promise applies to every charger install. If something isn’t right, one call brings Gus back. That’s not a slogan. It’s in writing.
Our EV Charger Installation Services in Encino
Level 2 Charger Installation
A Level 2 charger is what most Encino homeowners want. It runs on a 240-volt circuit, same as your dryer or oven, and it charges an EV in 4 to 8 hours depending on the battery. We install chargers on the wall of your garage, on a pedestal in your driveway, or on the exterior of your house if you park outside. We handle the permit, the wiring, and the final inspection.
Most Encino installs run $1,100 to $2,800, depending on how far the charger sits from your panel and whether we’re running conduit through finished walls or an exposed garage.

Tesla Wall Connector Installation
We install a lot of Tesla Wall Connectors in Encino. The Wall Connector is Tesla’s dedicated home charger, and it works perfectly with our Encino service area’s mix of Model 3s, Model Ys, and the occasional Model S or X up in the Hills. Our crew recently put one in on a gated drive in the Encino Hills where the panel sat in a detached garage 120 feet from the house. That job meant trenching through roots from mature live oaks without disturbing the heritage trees, mounting the charger on a pedestal, running conduit underground, and upgrading the main panel. The owner was charging by sunset. One trip, done right.
A Tesla Wall Connector install in Encino typically runs $1,400 to $3,200. The higher end usually involves longer wire runs or panel work.

Panel Upgrade for EV Charging
A lot of Encino ranch homes north of Ventura were built in the 1950s and 1960s with 100-amp panels. That worked fine when the biggest electrical load was a window AC unit and a refrigerator. Add a 48-amp charger pulling 60 amps, and you have a problem. We check your panel before quoting anything. If you have open breaker slots and the panel is in good shape, you might get away with a simple install. If the panel is old, full, or undersized, you need an upgrade.
Panel upgrades in Encino run $2,000 to $4,500. We use the same careful approach we bring to our Solar Panel Installation in Encino: no shortcuts, proper permitting, and work that passes inspection the first time.

Garage & Driveway Charger Wiring
Not every Encino home has an attached garage. Plenty of houses here, especially in the flats, park in driveways or carports. That means running conduit underground or along the exterior wall to reach the parking spot. We’ve trenched through decomposed granite, clay, and root systems all over Encino. We know how to do it without wrecking your landscaping, and we restore the area when we’re done.
Expect $300 to $800 in wiring labor for a typical driveway run, depending on distance and whether we’re going underground or along the wall. The charger itself is separate from that.

What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Encino
We work with equipment from Panasonic, JinkoSolar, and FranklinWH, among others. That matters for one reason: when we pair your EV charger with a solar array and battery through Encino Commercial Solar Installation, the components need to talk to each other. A solar system from Panasonic panels feeding a FranklinWH battery and a Level 2 charger should work as one balanced setup, not three separate boxes fighting each other. We stock common parts locally, so when a breaker or a connector needs replacing, we’re not waiting on a shipment from Ohio. We come out, fix it, leave.
Common EV Charger Installation Problems We See in Encino Homes
- Undersized panels on post-WWII ranch homes. The 1950s tract construction that fills the Encino flats was built for a different electrical era. Many of these panels are maxed out even before you add a 60-amp charger circuit.
- Long wire runs from panel to parking spot. If your garage is detached, your drive is long, or your panel is on the opposite side of the house, wire cost and voltage drop become real factors. We calculate the run before we quote, so there are no surprises when the bill comes.
- Heat and voltage compression. The San Fernando Valley heat island pushes Encino summer temperatures 10 to 15 degrees above coastal LA. That heat doesn’t just strain your AC, it stresses your electrical system. We size conductors and connections to handle sustained 105°F afternoons without overheating.
- Shaded roofs from mature live oaks. Encino’s famous oak canopy is beautiful, but it complicates solar-paired charging. We’ll get into that below, because it matters more than most installers will tell you.
Pricing for EV Charger Installation in Encino, CA
Let’s put real numbers on it. A standard Level 2 charger install in Encino, with the charger mounted next to the panel in an attached garage, runs $1,100 to $1,800. A Tesla Wall Connector runs $1,400 to $2,200 in the same scenario. If we’re running wire across a garage or down a driveway, add $300 to $800. Panel upgrades run $2,000 to $4,500 depending on amperage and condition. A full solar-paired setup with charger, panels, and battery is a bigger conversation, but for the charger piece alone, most Encino customers land between $1,500 and $3,200 all in.
We quote the real price up front. Bring us your electrical bill and your panel photos, and we’ll give you a number you can take two weeks to think about. The price won’t change. Call (877) 550-6892 for a free estimate.
We Also Serve Cities Near Encino
Our crews cover Encino and the surrounding San Fernando Valley. If you’re in Sherman Oaks, Van Nuys, Valley Glen, or Northridge, we can be there just as fast. The same local knowledge applies: LADWP territory, valley heat, homes built in the same era. One call covers the whole area: (877) 550-6892.
Serving Encino, CA - Our Local Coverage Area
We’re based in the Encino area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - EV Charger Installation in Encino
LADWP’s net metering program credits you for excess solar generation at a rate that makes solar-paired charging a smart financial move in Encino. When your panels produce more than your house uses during midday, that excess flows back to the grid and appears as a credit on your LADWP bill. You then pull from those credits when you charge your EV overnight. The math works because LADWP’s structure generally preserves more value per kilowatt-hour than SCE’s current plans do for customers in neighboring Thousand Oaks or Calabasas. That’s a utility-territory advantage specific to Encino. Call (877) 550-6892 and we’ll walk through your actual bill to show you the year-25 numbers.
Because Encino’s mature live oak canopy shades rooftops unpredictably. What looks like an open roof on satellite imagery can be partially shaded for hours by protected heritage trees. A traditional string inverter system loses the whole array’s output when one panel sits in shade. Microinverters or DC optimizers isolate that loss to the shaded panel only. In Encino, where oak shading is a real, documented condition across 91316 and 91436, these technologies are effectively mandatory if you want your solar system to meaningfully offset both home and EV charging loads. We do the shading analysis on-site, never from a remote tool.
Usually yes, but with limits. A 100-amp panel in a 1950s Encino ranch home can typically support a Level 2 charger set to 24 or 32 amps, which still adds 15 to 20 miles of range per hour. What it usually can’t support is a 48-amp charger pulling a full 60-amp circuit while your AC, oven, and dryer are all running. We do a load calculation before we install anything. If the math comes out tight, we’ll recommend a panel upgrade and give you a firm price for it. The older Zinsco or Federal Pacific panels we sometimes see in Encino are a different story: those should be replaced regardless.
Heat. Encino routinely runs 10 to 15 degrees hotter than Santa Monica or Venice on summer afternoons. That heat affects wire conductivity, breaker behavior, and the charger’s thermal management. We size conductors with the valley heat in mind and make sure the charger has airflow around it. We also know that Encino’s garage interiors can hit 100°F in August, so we avoid mounting chargers in direct afternoon sun against west-facing walls when we can. These are the details that come from doing the work here, not reading a spec sheet.
Yes, and it affects cost. The Mediterranean and Spanish Colonial estates in the Encino Hills, mostly in 91436, often have concrete or clay barrel-tile roofs. These require specialized tile-hook mounting systems instead of standard rail mounts, and there’s breakage risk if the crew doesn’t know what they’re doing. Gus’s crew does the install themselves. No subs, no hand-offs. Expect barrel-tile mounting to add $0.10 to $0.20 per watt compared to composition shingle, which on a typical 8kW system means roughly $800 to $1,600. The upside is that those tile roofs last 50 years, so the mounting system matters as much as the panels.
The Encino Difference: LADWP, Heat, and Heritage Oaks
Here’s what a generic installer’s page won’t tell you. Encino sits entirely within LADWP service territory, and that single fact changes how EV charger installations should be planned. LADWP’s interconnection process, its net metering tariff structure, and its Solar Incentive Program all operate differently from SCE, which serves Thousand Oaks and Calabasas just over the hill. If you’re pairing your charger with solar, and you should be given Encino’s sky-high summer utility bills, Solar Panel Repair in Encino and maintenance expertise matters because the utility territory you live in determines how much your exported electrons are worth and how long your approval takes. We handle LADWP paperwork for you.
Then there’s the heat. Encino is deep in the San Fernando Valley, and summer temperatures here routinely exceed 105°F. That drives your AC bill through the roof, which makes solar ROI stronger than almost anywhere in coastal LA. But it also means panel temperature coefficients matter. Sustained heat degrades output efficiency in the late afternoons, exactly when your AC is running hardest and your EV is plugged in after work. We spec panels with low temperature coefficients for Encino installs and ensure adequate roof standoff so air can flow beneath the array. This is not a brochure detail. It’s the difference between a system that meets its year-25 output estimate and one that quietly underperforms every August.
And the oaks. Encino means “oak” in Spanish. The mature live oak canopy that defines this neighborhood creates partial shading on residential rooftops across the flats and the hills. We do shading analysis on-site, in person, because remote tools miss what those heritage trees actually do to a roof at 4 p.m. in July. If you have oaks on or near your property line, you need microinverters or DC optimizers. There’s no shortcut around it.
LADWP rules, 105-degree afternoons, and protected oak trees. Those are the three things that make Encino different, and they’re the three things we build into every charger install we do here.
Get a Straight Answer About Your Encino EV Charger Install
Call us at (877) 550-6892. A live person answers, 24/7. We’ll ask about your panel, your parking situation, and whether you want to pair the charger with solar. Then we’ll give you a number. No pressure. No “sign tonight or lose the price.” Take two weeks. Think about it. The price will be the same. That’s how Gus has run this business since 2011, and it’s why Encino homeowners keep calling.
Written by Gus Petrakis, Owner at Gus’s Solar, serving EV Charger Installation in Encino and the surrounding San Fernando Valley since 2011.






Before
After
Before
After
Before
After